User Tools

Site Tools


repairs:afm

Repairs

Air Flow Meter

The air flow meter is of the mass sensing type. There is a thermistor in the air path which keeps tabs on the temperature of the intake air. To measure the actual mass, there is a small very fine wire strung in a square shape standing on a corner. A current is passed through this wire, heating it. The onrushing air cools the wire - the more air that passes over the wire the cooler the wire becomes. The resistance of the wire of course changes with temperature, the computer keeps tabs on the current draw of the wire.

The most common symptom of failure is that the engine will idle perfectly, but will not rev over approximately 2000 rpm.

The wire gets stuff on it while operating, which impedes heat transfer so the wire cleans itself each time the engine is shut down. The computer puts enough current through the wire to heat it until it's white hot, which presumably burns off any stuff from the wire. On turbos the wire is only cleaned if the car is under 239F, has been above 1500rpm, and has been driven at more than 12mph. Non-turbos are cleaned when the engine is shut off and it's under 239F and has been run at more than 1500rpm, regardless of being driven or not.

To test your air flow meter, Drive your car around the block. Remove the air filter and the tube leading to the air flow meter WITHOUT shutting the engine off. Be careful to not let anything get sucked into the engine. Have an assistant turn off the engine while you're looking down into the air flow meter. If the wire doesn't glow, your air flow meter is bad. Rebuilt air flow meters are available for about $200.

repairs/afm.txt · Last modified: 2022/08/04 17:38 by 127.0.0.1