| |||
| |||
I belive those instructions tell you to jump a 6-pin connector. But when I did mine I couldn't find this connector because I had an 84-style auto trans. The connector you want to jump is the 4-pin that you pulled out of the tranny. Facing the connector, the right side 2 go to the brake switch that you swapped out for the clutch switch. If you wire it to the neutral switch on the trans, make sure the switch has continuity in neutral. The left side 2 go to the reverse switch on the trans. I just hope you didn't short out the ECU by jumping the wrong connector, that would suck.
No, you do not need to change ECU/wiring for the swap.
: I considered swapping trannys on my 300zx, but after I talked to the Nissan dealer, I decided against it. They told me that I would need to change the ECU and most of the wiring, making the change would not even be worth the money it would cost.. but you can always try I guess! =)
